Showing posts with label weaving tools. Show all posts
Showing posts with label weaving tools. Show all posts

Tuesday, December 28, 2010

Homemade Raddle - Denise

Here we go. After my adventure (fiasco) using sectional warp with my camp towels, I discovered that irregular stripes were probably easier and wiser to do with a warping board and then warped using a raddle.

I didn't have one. I looked up on some sites and found that ones for my loom would cost around $50 + s/h. I searched some sites and found that I could indeed make one for myself.

I looked up and found that 1x2 pine lumber is about $5 for 86". Use a soft wood so it doesn't split when nailing. Otherwise you will need to drill a small starter hole.That would give me 2 raddles of 43" for my 36" loom. That puts 2" beyond the desired loom width to clamp. The finishing nails I need are 1-1/2" bright finishing nails. I could buy 1000 or a smaller assorted box for $2.99.

I don't like sanding so I painted mine with leftover satin paint, 2-3 coats. I measured roughly 1/2 way down the good side and drew a light line. I then made 1" marks for where the nails would go starting with the center and moving outward from both sides.



I then started at one end and carefully hammered the nails in. On the second one I left the very end one off. I needed something to clamp, logically. I'll go back and pull the end nails later.


I only hit my thumb once when distracted. I painted the center with fingernail polish. If desired, I could drill a hole in the end and put a eye bolt in so I can hang it from the wall when not in use.


This won't snag on yarns. I'll keep you updated on how it works.

Monday, November 1, 2010

New Spool Rack (Denise)

I've been waiting for my dad to make me a spool rack. For a variety of reasons, the project has been put off. Well, I got tired of waiting since my loom was sitting empty and was ready for my next project. I needed a spool rack to use with my sectional warp.

I made my own spool rack out PVC pipe. This is functional, and almost literate as a weaving tool.
To make this project, you'll need the following:
  • 4 - 90 degree elbows
  • 2 - 10' lengths of 3/4" PVC pipe (I found some pre-cut lengths so I only had to buy one)
  • 2 - 1/2" pipe about 2' long (I found some pre-cut lengths)
  • PVC pipe cutters (I used the ratcheting kind)
  • tape measure
  • permanent marker
  • 3/16" round wire (for the spools)
  • drill and drill bit larger than 3/16"
  • bolt cutters (cut the wire)
  • 2 self tapping screws 1-1/4" long
This construction is not exact science. So, decide a how many spools across? I did 4. It came out about 20-1/2"... on the inside, give or take. The wire needs to be a bit wider than half-way so it will stick in the holes and slots. The permanent marker is good for marking on PVC pipe.

It's about 41" long. I measured every 4" (centered 2" for the holes) along the sides on an extra piece as a template so the sides would be even. I drilled holes on one side and a slot on the other. Again this isn't exact or perfect. It will do, for now.

The 3/16" gauge round wire comes in 36" lengths. I could get 2 sections. So for 40 spools, that's 5 wires cut roughly in half and trimmed to fit.

The last step was to drill the 1/2" PVC pipe to the 3/4" pipe using the self tapping screws as a support.
Good luck!